Posted by George Rausch on March 18, 2012 at 11:04:07 from (64.85.216.102):
In Reply to: Hay carrier/trolley posted by Riverslim on March 18, 2012 at 10:40:39:
Oh yes, four huge hooks grouped together, and shaped like spider legs. You lowered them down from the loft peak, on their own pulley, spread them out on top of the hay, on top of the wagon, and stomped them down into the hay. If you got hooked into the floor-boards of the wagon, you also lifted up the wagon..... take up the slack, lift up a load, and as the load hit the peak, you HIT IT, and the load clicked up into place, into that carrier you have, and it slid back inside the loft. Then you gently pulled the load back inside the loft to the correct spot, made sure the kids were not under the load (as I found out, when I was 6 years old) and trip the trip rope, and the load dropped. A hot miserable dirty dusty way to do it. Never forget the first time Pop had square bales made up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
