Posted by omahagreg on March 16, 2012 at 18:15:39 from (72.213.46.156):
As a trim carpenter, I depend on my air nail guns. Have 3 different types for doing trim specifically. My largest one shoots a 2.5" 15 gauge finish nail, and is used mostly for setting door frames. Been setting doors and some thick casings all week, so it has been in great demand! Today it decided to shoot 2 nails at once, and got hopelessly jammed up! Carlson Systems in Omaha is where I bought them, and they have a service department. Finished the day, and by 4:15 I was at Carlson. Told him I had 4 more doors to set, and I joked about how it could not quit when it WASN'T needed! He proceeds to take it apart, clean it, test it, then offered preventative measures, AND did not want even a penney for his trouble! I was IMPRESSED!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
