Posted by JDseller on March 14, 2012 at 23:16:40 from (208.126.196.144):
In Reply to: Coulters or not? posted by Erik Ks farmer on March 14, 2012 at 15:56:26:
In hard ground and sod you need the coulters. I have never seen the case where the coulters caused a problem. As far as a "crust" falling back in??? I have no clue as to what he is talking about. Now If you are running real wide fluted coulters they can cause issues with drying the ground out by working too wide a seed zone. Around here they usually use a 3/4 bubble coulter that did not do much but start the seed trench. Also you want the coulter to be a little higher than the double disk openers. Let them form the seed trench. So if you are planting 1 1/2 inches then the coulters need run at 1 inch.
I run a 25 wave 3/4 inch wide coulter with row cleaners. Mine is a Dawn set up. I like the depth adjustment better then the Yetter pin and hole setup. I also run cover chains to rub out the press wheel tracks. They will wash in a real heavy rain. I tried the spiked closing wheels and they did not work in my soil type. Not good enough soil to seed contact.
What I have found out in no-tilling is that different planter/attachments will work different on different farms/soil types. So what you neighbor does a 1/4 mile from you may not work well on your ground.
I would start with what you have and then just adjust as you go along and learn your ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
