Posted by NCWayne on March 12, 2012 at 07:48:58 from (69.40.232.132):
In Reply to: o/t gas golf cart posted by Chief 83 on March 12, 2012 at 03:35:19:
if you've got it running try putting about double the concentration of Seafoam in the gas as recommeneded on the can and just let the engine run for a while. Start out for a while at low idle and then open it up and let it run at high idle (no load) for a while. Usually this will clean out any varnish present in the carb.
I've had this work for me many times over the years, but there are times when it works...but it doesn't. By that I mean over the weekend I got an old two man auger I own running after setting for close to eight years. After doing what I described above I got it where it would start with a small shot of ether, and idle with the choke on, and eventually to where it would start and idle properly, no choke. Once to that stage I moved to high idle and got that working too.
When I finally got started helping my neighbor put in a few post holes it worked great for about 6 holes. Then it started dying under a load but would still idle perfectly. I'm pretty sure what happened was the Seafoam broke lose a piece of varnish somewhere and clogged a jet in the high speed side.
Like I said it worked, but it worked too good so now I have to open up the carb again and do another thorough cleaning. In the end it's well worth buying a can of Seafoam and trying it before you tear into the carb. Worst case it's good for the gas, and will help clean anything out of the carb you might miss if you do have to tear into it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
