Posted by mike klein on March 10, 2012 at 18:23:50 from (72.60.88.84):
This message is a reply to an archived post by John Kenny on November 09, 2011 at 04:00:12. The original subject was "Allis G, basket weeder setup".
I have seen a tube extender for G which bolts between the front and center torque tube.
I can forward you the plans. If you send your email. Length depends upon the confidence in your welder. If your tractor is hydraulic then you might need to extend the hoses.
I have also taken the A fram single row cultivator off and replaced it with a 2" square bar. The square set up allows you to use danish S tines available through Agri Supply.
To make the Square bar fit into the bracket you need to have someone shave off about 1/4 inch off two opposing corners then drill a 7/16 hole to secure the bar to the cultivator bracket. I used a 1/4" thick walled squared tube. Consider where you want the brackets to attach. You may need to adjust the lift assembly to accept a wider spacing so you have flexability in spacing the tines.
You can also just drop in a 2" diamond (square turned 45 degrees) and use it as a diamond bar but these diamond brachet attachments get expensive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
