Posted by Detmurds on March 10, 2012 at 08:28:53 from (67.142.130.26):
In Reply to: Standing broom posted by c-man on March 09, 2012 at 10:04:27:
The trick
Take any flat-bottomed broom (it can be angled or straight) with relatively stiff bristles and stand it up so the bottom is flat on the floor. Try balancing it and letting go. If it won't stay upright by itself (some will, some won't, depending on weight, dimensions, and center of gravity), then push straight down, forcing the bristles to spread apart on each side (depending on the particular broom, you may have to use your fingers to spread the bristles evenly). Then gently let up on the downward pressure, balancing the broom upright as you release it. The bristles will retract but not completely, forming a relatively stable base and allowing it to continue standing by itself.
It may not work every time, mind you, or with every single broom, but in my case it worked on the very first try with the very first broom I grabbed. Try it!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
