Posted by Check Break on March 08, 2012 at 23:04:51 from (96.238.223.127):
In Reply to: concrete wash pad posted by bill mart on March 07, 2012 at 15:24:47:
A 6" slab is fine. Do not cast a footing around the perimeter. Wire mesh will work. You might think about No.3 rebar but rebar will cause more cracks than wire. Saw cut control joints in the slab 1/3 the depth of the slab on no less than 10' x 10' centers the day of placement, not the next day or a week later. DO NOT dig the slab down below grade. You want to break the bond between the slab and the ground. Burying the slab will increase the bond and prevent the slab from moving when the ground freezes and heaves, causing the slab to crack. Talk to your local ready mix company about base. Does anyone in your area use 1.5" drain rock or pea gravel for base. The ready mix supplier always gets accused of selling bad concrete when the cracks appear and will be well informed about what you need to do to avoid a similar problem. Put as much rock as you can afford under the slab and drain all the water away from the slab and the base. A wash pad in an area that freezes is just waiting for the ground to expand and heave. If the slab is totally separated from the soil, it will rise in one piece and subside in one piece when the ground thaws. Hope this helps.
There's 200 ways to screw up good concrete. You didn't mention what time of year you would be placing the mud and what the weather conditions would be like. These factors will have a big impact on your slab as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Silver King - by Staff. Silver King tractors were produced by the Fate-Root-Heath Company of Plymouth, Ohio. The company was founded by John Fate in 1884 and was originally called the "J.D. Fate Company". After several mergers over the years, the final company name of Fate-Root-Heath came about in 1919. The first tractor produced was actually called the "Plymouth" tractor and was powered by a 20 HP 4-cylinder engine with a 3x4" bore and stroke. The four speed transmission had a top speed of 25 mph! After more t
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
