Dang it! I didn't even think about the wet/dry shop vac! I made a hose with a valve stem on it and tried to blow the water out the top through the faucet or at least blow the lime away from the drain so I could get it out through a hose into a pail. Didn't work as well as I had planned. Was wishing I had a vacuum pump for a milking machine,but don't have one with a motor on it anymore. I tried pulling the element,was gonna hold a radiator hose on the fitting to get it in a pail. That didn't work either. Just ended up using towels to herd the water toward the holes where the pipes come through the floor.
Real blich of it is,I had to open everything back up again to get to the new one,then take the cover off and adjust the thermostat. Wife said it wasn't hot enough. Darned thing was preset at 110 degrees from the factory. Was in a hurry and didn't think to check that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
