Just a little story about generators. Power was out my neighbor had a 37 K generator. We put it on a 1370 Case that had just a 1000 rpm pto. Just revved it up till we had 130 Volts on each leg. Next day needed to grind feed. He has a automatic mix mill.Grinds with about a 7 hp electric motor. then a mixer don't know the hp. then to a blower another 7 to 10 hp motor plus other assorted motors running small augers. Plus the fans on 4 buildings. Bottom line wouldn't run the Mix-mill. Took a long time to figure it out, but the pto in the 1370 was slipping. Put a 806 IHC on the generator, Yes we used the 540 shaft and it pulled it fine. That 1370 had pulled a 15ft Bush Hog before, and did also that summer. I guess at that slow speed didn't have enough hyd pressure on the pto clutch. Vic
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Perfect Restoration - by Chris Pratt. Often, in quiet moments, I have wandered back in my thouhts to the many tractors I have seen over the years and wondered which one inspired me the most. Sure, we have a fond attachment to one brand and model or another, sometimes it was remembering that first time we got to climb up in the drivers seat and command that roaring beast, or maybe because when you see that special model, you can't help but see Dad on it, he's gone, but everytime you see a tractor like his, it's a like part of him i
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
