Posted by JMS/.MN on March 02, 2012 at 18:59:41 from (209.237.107.155):
In Reply to: Re: thanks posted by paul on March 02, 2012 at 18:41:56:
Might be that not all holes are egg-shaped the same way, so a drill, reamer, etc. will give you a round hole but not necessarily centered like the original. You mentioned H brackets....what, two straps welded to a pipe spacer? Could easily start from scratch to make them. Drill the holes in new straps, build a jig to hold the 3 pcs together, and weld them. For the jig, I"d use two angle irons welded on a couple of spacer flat irons, with holes drilled to match the straps. Might use a small channel in the location of the spacer pipe, to hold it. Bolt the straps to the jig, add the spreader pipe, and weld in place. Should end up with 15 identical brackets.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
