Posted by rustyfarmall on February 29, 2012 at 07:23:58 from (216.248.71.224):
In Reply to: Modern spark plugs posted by David from Kansas on February 29, 2012 at 07:11:59:
Quoting Removed, click Modern View to see
Denny's is still in business?
Those 560s have been running just fine for over 50 years now without a 55,000 volt coil OR electronic ignition. Autolite 388 plugs along with some solid core plug wires is as good as it gets.
Does the carburetor still have the electric solenoid? If so, you might want to get rid of it and replace with the adjustable load screw set-up used on the Ms. That should take care of that sooting up issue.
I think the hesitation encountered with quick throttle movements is kind of an inherent problem with the 560s and 706s. You might not ever get it to go away completely.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
