Posted by Indiana Ken on February 27, 2012 at 16:13:40 from (66.249.234.170):
In Reply to: water line volume?? posted by Tx Jim on February 26, 2012 at 12:41:18:
Quoting Removed, click Modern View to see
Wow - you are filling a large tank. Yes - you may want to change out the 1/2 inch section of line. Again for copper line, 1/2 inch (.527 ID); a flow rate of 5 GPM will result in a head loss of 57 feet per 100 foot of line and at 10 GPM the head loss increases to 205 feet. I am surprized you are using a 1/2 hose, if it is of any length you may very well see an increase in flow simply by going to a larger hose. For example, if your hose is 25 foot long the pressure loss in the hose alone is 6 + PSI, at the currrent flow rate of 5 GPM.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
