As a mechanical engineer I'm going to throw this out there for comment....
The days of the farm grown engineer (with or without degree) are a thing of the past. We very rarely get any new engineers with any practical sense, and in my opinion engineering school are stressing the wrong things. Too much time is spent on computers including FEA and not enough time on how to make things; both physical manufacturing, ease of assembly/maintenance, and functionality.
It's possible that with that size nut and tension in the rod that is what the torque actually calculates to. Doubtful though.
But as stated above, I'd rather have it be a PITA to take off than have it come apart when I didn't want it to.
I'm going to post a poem I've got framed on my wall for your enjoyment since I think it pertains.
And remember, its more often the bean counters fault than the engineers....
The Successful Designer
The designer bent across his board wonderful things in his head were stored and he said as he rubbed his throbbing bean how can I make this hard to machine
If this part were only straight, I'm sure it would work first rate, But 'T would be so easy to turn and bore It would never make the machinist sore.
I'd better put in a right angle there Then I'll watch those babies tear their hair Now I'll put the holes that hold the cap Way down there where they're hard to tap
Now this piece wont work, I'll bet a buck, For it cant be held in a shoe or chuck; It cant be drilled or it cant be ground In fact this design is exceedingly sound.
He looked again and cried, "At last-- Success is mine, It can't even be cast"
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
