Go to a gun shop and buy a pound of black powder. Also buy a length of cannon fuse. Most gun shops that cater to muzzleloaders will have this.
You will also need a length of 7/8" wooden dowel rod and a 3/4" concrete bit.
Cut the dowel rod in about 1 foot lengths. Using a plane or rasp, taper one end so it will fit in the 3/4" hole you are going to drill in the rock. Then using a saw, cut a groove in the dowel lenghtways so the fuse will fit in the groove.
When the dowel is done, and several hours before the project, soak the dowel in water.
Drill a 3/4" hole in the rock as deep as you can.
Make sure the hole is dry, then fill about 2/3 of the way up with black powder. Just leave 2 inches or so from the top, enough space to drive the dowel in securely.
lay the fuse in the groove in your dowel, then preferably using a wooden headed hammer or a rubber hammer. Drive the tapered end of the dowel in the hole as tight as you can. Drive it in against the powder to compress it.
Then, make sure there is no exposed powder, and that you have a good long lenth of fuse. Streach the fuse out and keep your body as far away from the hole when lighting the fuse.
Light the fuse and retire to a safe distance.
I needed to remove a huge limestone rock from a friends back yard. Using this method we blew it into 6 or 7 managable pieces that we could carry away.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
