Posted by ErnieD on February 14, 2012 at 07:58:42 from (67.253.193.102):
In Reply to: EPDM gaskets posted by Fixerupper on February 14, 2012 at 06:34:35:
EPDM is superior to Buna N and short of TEFLON. If you are concerned, and should be, check with your supplier and ask what their experience is. Another alternative is to "cook" a sample at elevated temperature. Each 10 F doubles the rate.
Protect the poly tank from sunlight and support the piping to prevent mechanical stress. Inspect the gasket periodically.
If you need to enter the tank ensure the tank has been cleaned and purged and mechanical ventilation is used. If entry is restricted have a means of rescue.
Check your states DEQ; DEC or whatever their EPA state plan is called to see if your tank requires registration.
Have a plan in mind on how to mitigate a leak. Most leaks develop slowly. (Is there a truck terminal you can call to off load the tank so R+R can be accomplished?)
Ammonia solutions are notorious for slow leaks. I would recommend a impervious slab, with grooves or a grate to aid in leak detection. Keep a written inspection record to document you are aware of the hazard.
Do you have insurance for chemical releases?
Minimize inventory days in storage to control risk.
The two happiest days were when I had a 10 tank farm and when I did not.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
