Posted by rrlund on February 10, 2012 at 06:51:58 from (207.241.137.116):
In Reply to: idiot service posted by Don-Wi on February 09, 2012 at 19:10:26:
Should have seen the look on the parts gals face at the old Oliver dealer where I go. I needed something,don't remember what it was,but the water pump was out on the 1600 at the same time. The other Agco dealer farther over beyond them that used to be an AC dealer had what I needed,so I asked Shawn if they could press that cast hub off that 1600 water pump and rebuild it while I went on over and got that other part. Told her I'd do it myself at home,but I was afraid I'd break that hub. She said sure,no problem. I got back there about an hour later,walked in and she had a sheepish look on her face. I said "they broke it didn't they?". She just said yup. They're not very far from Worthington,so she called them to see if they had one,they didn't. Luckily,it just broke one side off and wasn't near the shaft. I took it home,ground it in,clamped it and welded it. Been quite a few years ago and it's still holding.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
