I started in in 1985, I think. I had an old nasty 8x35 trailer that leaked on sunny days, and froze my butt in the middle of the summer. I didn't want to put my house anywhere else, and I didn't dare move the trailer and try to live in it afterward. So, I had a foundation trench dug around the trailer, and twice as wide. we poured a footing and laid a block wall on top of it,covered it with hay and waited til spring. That summer and fall, we framed the house, sided it and put on half the roof, In the spring we finished the roof, and started the inside. In the late fall we opened the end of the house and pulled the trailer out, kitchen bathroom and everything. Through the winter we camped out in the shell, living out of the microwave and one cold water faucet while we finished the kitchen, bathroom and most of the living room. In 1991 we had our first child, and work on the house came to a screeching halt. The second boy was born in '93, and it was '98 before any more progress was made. Work has continued in fits and starts, as money and time has been available. It is still a work in progress, and probably always will be.
Here are some facts about the build: All the lumber came from my father's farm. I was working for him full time until 2000 He was generous with his own help, and the use of any and all farm tools and equipment, and cut me considerable slack as to hours of work. It was all pay as you build. A good friend of mine helped me for a lot of the design, and much of the actual construction. He was working off and on during this period, and would help out for a weekend at a time for beer and food. This is a rural area and pretty lax a far as permits and inspections, no bank involvement also gave me leeway that might not have otherwise been available. I don't ever intend to sell it, so I didn't have to consider the requirements of a hypothetical future buyer.
One piece of advice, if there is any way to avoid it,DO NOT TRY TO LIVE IN A HOUSE WHILE YOU ARE BUILDING IT!!!!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
