Posted by mkirsch on February 02, 2012 at 07:13:08 from (64.80.110.75):
In Reply to: More Electrical stuff posted by Mike (WA) on February 01, 2012 at 08:49:12:
Ground and neutral go to the same bus bar(s) in the main panel.
The way I understand it, the ground line running through the wall is not meant to carry current normally. It is there just in case something goes wrong, to provide a path to ground that doesn't involve your body.
In -2 Romex, the ground wire is bare copper. It is lacking the insulation that the other normal current-conducting wires have.
You need a separate, fully-INSULATED, neutral wire because it's carrying current, even though both wires end up in the same place.
That outer jacket on the Romex is meant to protect the insulation on the wires, not to be the primary insulator. One pinhole or nick in that outer sheath on a run that uses the bare copper as a neutral is a potential problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
