Posted by NW Ohio Tim on February 01, 2012 at 08:04:54 from (76.76.36.32):
In Reply to: Just label it! posted by rlp in co. on January 31, 2012 at 18:48:00:
First off, I'm not opposed to GMO food. I use antibiotics in my pigs when I need to and if you want to put hormones in your steers, have at it. There are alot of people not starving today because of abundant cheap food.
Now then....
This whole thread is what is wrong with things today. It started out as a post about GMO and has turned into just a bunch of people yammering. Pretty soon, the people yammering the loudest get to a lawmaker and we have a regulation that was based on no fact or knowledge.
GMO refers to genetically modified by gene splicing.... at the DNA level. It's not crioss breeding or artifically inseminating or fencing pastures!! Quit trying to muddy the conversation. Should it have a different name?? Who cares, it's the one it has.
I just had this conversation with my sister in law last week. Here's what I told her to make her understand better. Here's the GMO For Dummies explanation in a nutshell: cornstalks used to start to rot before the grain was harvested and they would fall down. Scientists discovered peanut plants didn't, so they went in and found the gene that kept them from rotting as fast and replaced the corn gene with the peanut gene. Now the corn stalk doesn't rot as fast. Corn plants and peanut plants would never cross pollinate, so that is genetically modified.
That's over simplified but she understood. Now lets quit talking about hybrid vigor and GMO in the same terms, it's like saying the caveman that invented the wheel put a man on the moon.... it's kind of a stretch.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
