Posted by dave2 on January 23, 2012 at 06:15:56 from (79.240.152.253):
Hey, Got my blade picked up the other day... Think I am happy...
Positive experience #1 was... I went bto pick up either a yellow or primered blade and got ba red and black one... Matches the tractor (IHC) perfect because of the red tractor with black on a couple of things (to include the FEL when I find one), and the Rubber cutting edge is white instead of the green I thought it would be so makes it a perfect match...
#2 was with the unions... Everything here is unionized to an extent...
Was sopposed to pick up an assembled product, but the guy at the store that assembles was out sick and the store onlöy had one assembly guy...other guys weren't hired for that.... Got a 70 buck discount ansd extra 3PH pins along with the rack mit came in... Rack is the perfect size to bolt on the wall above my crimper to hold drums to store grain....
Just have to figure if I can use my quick hitch from HF on it or hook up the old fashioned way.....
And... the blade is 1/4" and the black cutting edge is 3/8"... Should handle my poop just fine....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
