This is the traditional "drive-in" tractor and equipment shed. You can make one bay or 20 bays. Custom tailor to what you want. Easy to add sliding doors later too.
A few warnings though.
1st. - you cannot easily buy pressure treated 4X4s anymore that are rated for ground burial. Use 6X6s and even then - you have to be careful. Many 6X6s are also not treated enough for burial. Ask before you buy and keep in mind many counter-people at lumber yards are clueless. When CCA was the common treatment, this was easy. The new chemicals are more expensive so many 6X6s are ordered with the light "ground contact" treatment - instead of what's needed for burial.
2nd. - snow load. Where I live in central New York, a 20 foot span requires 2 X 12" on 16" centers - NOT 24" centers. Your area might differ a lot. The plans I attached with 2X6 rafters wouldn't last one winter here.
3rd. - wind load. If you have a prevailing wind that will commonly hit one side of the shed, you might want to use 2X6s on the sides instead of 2x4s.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
