You constantly amaze me! How you can work in such a cold environment, although you have a heated shop, but you do stuff outdoors also. My shop is not yet heated, and at this age (sixty 6) I am getting to feel the cold a lot more than I used to. I have a few big projects in slow motion, but as it warms up a bit, I'll be back on them. Thanks for your frequent updates.
Can I vote on your next project?? I'd like to see the Prairie Gold up to its useful self again. I have 2 smaller MMs as well, a ZB and a UB Special. The ZB gets used often for moving wagons around the yard and pulling out some firewood, and the UB is near runnable, but I need a steering part for the wide front (the part that slips into the V shape dovetail notch on the bottom of the steering motor, and drops down to allow the attachment of the plate that holds the centers of the 2 tie rods. I may end up making the necessary part, as my son recently won the bid on an old Bridgeport mill. But I need to come up with a 3 phase converter before I can run the mill. And I am making an insulated machine shop room within the big shop. It was -25 C here this morning (-15 F). But it has been one of the warmest winters on record here, west of Minneapolis.
I enjoy your pictures and would love to have even 10% of your energy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
