Different crops bale different. As previously stated normal bad bales especially soft sided bales are caused from the OPERATOR not doing his driving job correctly. To make firm sided bales the windrow must be crowded on each side. This is accomplished from weaving back & forth or large windrows. I've been acquainted with and operated/demonstrated rd balers since they first came out. I can't count the number of times I've be told that there is something wrong with the baler because the operator couldn't/wouldn't make a good bale of hay. Then I get on tractor and prove to them it's "only operator error" not the machine. There have been a very few times when the condition of the hay will overrule but very few. Usually it's the operator. Running a rd baler correctly is an art and more difficult than it appears.
DISCLAIMER: I have no experience with a soft core baler(tumbling) nor desire any experience with one.
This post was edited by Tx Jim at 09:13:55 01/18/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.