I'd just about guarantee it. To them whether it's a corprate job, or a job for a private entity, a pick is a pick. Either way they are liable for the setup, the rigging, etc, etc so they aren't going to take a chance of going into a job without all of the information needed to do it safely. Like I said give them a call. They may be able to give you a ball park estimate over the phone using your figures but if your serious I know they'll send somebody on site to get their own. What they'll need wil be the weight and possibly the dimensions of the pipe, and some sort of idea where it's going and how close the crane can get to where it needs to be picked from and set. Too they may also need to know what will be needed to rig the piece. I say this because the way OSHA has gotten about anything crane and lifting related they may have issues using anything but their own rigging, unless the rigging from the pipe's supplier has the proper capacity markings/tags. Once again good luck with which ever direction you choose to take.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.