Good point, if it wasn't running good, I probably wouldn't have had a chance to buy it for that price. I have seen those welders sell used for what he was asking plus the repair bill, which blew out the circuits in a board.
I do board repairs on everything from X-box to radio control helicopter controllers with some components being 1/4 the siz of your pinky fingernail with 8 pin face mount chips, up to large capacitors that are soldered through the board. Not a big deal, unless I don't have a schematic. So, I'll chock one up to being too mild.
I should have stopped him.
I just figured that he would have listened to me when I told him several times. I guess those that know it all will always know it all. I run across it all the time on a daily basis.
Regardless, it makes me mad. I seem to always be mad about something. Perhaps ignorance is bliss. If so, can someone hit me in the head hard enough that I end up mopping floors at McDonald's and feel happy again?
Or...
I'll just go out now and tig 2 beer cans together... That is pretty blissful!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
