You're wrong about woodturning not being tractor related. My last woodturning project was to make a clutch alignment tool when I split my tractor.
Congratulations on getting into woodturning. I believe you will find that its the most fun of any woodworking tasks. My first project in woodturning was in high school in 1970 where we turned the legs for foot stools. It was a very simple project but it gave the experience of making four turnings alike. Today mostly what I turn is replacement parts for furniture restoration. I would recommend that you only turn wood between centers until you get some experience before you start something like bowls. If you have access to a soft hardwood like alder, soft maple, walnut or mahogany I think it would be better for you to start with. If you try to use a harder wood like ash or oak you would have more incidents where the tool grabs. I don't go overboard on sharpening tools. Some people hone the tools but they wear down too fast to go to that trouble. I sharpen mine only with a grinder.
I've always recommended that someone learning woodturning find a simple project and build it. It has the effect of focusing your attention on what you are doing right and wrong. If you just stick a piece of scrap wood in the lathe and make shapes you don't learn to measure or make anything useful. When I was in school we did that for about 10 minutes to get the feel of it an then started making parts. I believe I ended up having to throw one of the stool legs away and make another because it was a little different than the other three.
I wish I had more pictures of turnings. This table is the only picture of something with turnings I've built I can find.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
