Posted by Ralphwd45 on January 02, 2012 at 16:34:10 from (216.227.110.4):
In Reply to: Re: Vinegar posted by Mike (WA) on January 02, 2012 at 15:40:09:
No Mike, I have the two cyl's mounted, and got the generator-pump back from the Hamiltons, and feel sure that it should work fine. I called larry, at Allstates in Downing Wi, and asked him to send the original brackets , from the super 55 that he took the generator-pump off of. I put the rear angle bracket on the block, and it fits ok, but the casting front bracket, that he sent, eludes me ,as to how it is suposed to fit on the tractor, and the genny. Probably have to drive down to Chehalis, and take another look at your rig.I have been waiting to get healed up from my broken foot,and not doing much, except feeding my cows. Thank God for the WD45,with loader, and large round bales, it sure makes it possible for a cripple, to feed his stock.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
