If you can find someone who has a shear on a skid loader they can be sheared off at ground level. The people I harvest with cash rent some land that had been in CRP and the cedars had come up in it pretty bad. The landowner took it out of CRP when the contract was up and wanted it farmed. The farm manager had someone come in with a skid loader with a shear and he did a good job. To save a little money the landowner said he'd cut the cedars in one corner of the field. He hacked them off at six inches or so. The land is in a conservation plan and can only be no-tilled so soybeans were no-tilled. That fall (2010) the floating cutterbar hit a stump and it bent the cutterbar to the point where they had to replace it after the season was over. It's too bad your cedars couldn't have been sheared off right off the bat while they can be seen because cutter bars and hidden tree stumps don't get along together very well. The cutterbar on a haying machine is probably tougher than the flex bar on a beanhead bit it's still a bad combination, and Cedars don't rot away very fast. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1941 John Deere B Row Crop - by Anthony West (UK). The 1960's promise of white hot technology, to relieve us of the drudgery of everyday work and to replace it with increased leisure time has not materialised just yet....if anything most people are caught up in an ever increasing rat race, wishing that there was at least 36hours in a day!!!. The need for people to escape for periods of relaxation in an increasingly complex and pressured environment takes us into the realm of hobbies. For some it's scaling high mountains for others it's putting p
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
