Posted by BushogPapa on December 30, 2011 at 08:12:21 from (173.88.50.86):
In Reply to: Re: JD A pulling power posted by Glenn Warner on December 29, 2011 at 19:36:19:
Spend ALL the time it takes to get the parts that contact the soil SHINED-UP... You will THANK yourself more than 100 times...!!!! A rusty plow is really more like an ANCHOR than a plow... I start with a 4 /2" angle-grinder with a cutoff blade, held at about a 30 degree angle (Wear a Mask) it will clean that rust off, right down to the Black Oxide under the rust but won't scratch through. The Black Oxide will scour just fine.. I like to complete the job with a "Flapper-Wheel", to get any areas I missed with the cut-off wheel May take one cutoff wheel per plow bottom.. Ron..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
