Posted by jackinok on December 30, 2011 at 08:12:15 from (162.58.82.136):
In Reply to: JD A pulling power posted by Glenn Warner on December 29, 2011 at 19:21:12:
back when i first started farming i pulled a two bottom with mine.did a good job in most soil conditions.I would use a 16" one bottom breaking new ground and really hard clay.Didnt have any weight though which would have helped of course.I sort of aggree with the others on the three point.While their are some good kits available,the cost of them would go a long way towards buying a good trailer plow and other equipment. Went to an auction a couple of weeks ago that had a couple of good jd sycle mowers,one was a 39w,the other a model8,one brought $10 the other $12.You can still find pretty good equipment to fit that A around at a good price.And to be quite honest ,in my opinion they work better than ones that have been converted.Only advantage i ever saw at all with three point stuff was draft control,and you would have to get pretty sophisticated with a aftermarket kit to have that on a A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
