Posted by buickanddeere on December 29, 2011 at 12:25:12 from (216.183.148.30):
Original brick & clay flue liner chimney dating from 1977. Chimney runs straight up through the center of the house from the basement fireplace. Approx 25ft total length/height. Probably had several chimney fires and/or too hot of fires. The clay flue is cracked and smoke in the past has seeped through the brick and mortar. Then out and through seems in the drywall. One roof truss in the attic which runs tight to the chimney brick mortar gap is blackened, scorched and feels "dry". Going to cut the damaged section of truss away. Offset the section away from the chimney and replace with a piece to support the sheeting. The original firebox/heat exchanger had been torched out 20+yrs ago.A high efficiency air tight fireplace fan forced heat exchanger had been installed. Along with a flexable stainless liner. 2011, the stainless liner in the chimney has recently developed pin holes. In the first 2-3 ft from the fireplace. For the moment I pulled the liner and turned it end for end to put the pin holes at the top of the chimney. What to do? There is 304 flexible stainless liner and rigid 304 single wall stainless liner. Can't seem to find double wall liner for use inside the old clay flue? There is however insulation blankets listed to wrap the flex or rigid single wall liner. I haven't lit the fireplace yet this year and won't until the chimney is repaired. Unless an emergency to heat the house if the power is lost. Outside stack really isn't an option as the existing brick chimney rests on top of a massive 8ft wide, 3ft deep, ceiling height brick mantle. Knowing the 1st owner/builder's methods. The fireplace mantle is probably holding up the main floor and walls above it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
