I change many car and implement tires here and when I checked my Jeep tires (it had a shimmy problem), I found they were not that well balanced.. I asked the tire Dealer about it and he said "there is NOTHING Better" than a Bubble Balancer..!!
A lot depends on how much time you take to get them accurate.. If I have a choice, I put 1/2 the weight on the inside and 1/3 on the outside..but have no problem with a single weight on the outside..
Problem I have is, the Newer wheels..some have a center hole too small for my changer/Balancer..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
