I also live in Michigan. I built my home 11 years ago and I had an excavator dig out the top 6 inches of soil and then lay in 4 inches of fill sand then the heavy 1x3 limestone rock. After 2 or 3 years of drving on this then I bought about 60 yards of crushed limestone (small gravel) to "cap" the driveway. Propane trucks, dump trucks, you name it no problems. You have to have good drainage so that standing water doesnt make it a soupy mess. My driveway costs about five or six thousand total. I still would like to get another 20 or so yards of stone put down to even it out. BTW; my driveway is 850 feet long. My MIL has an old friend that had a gravel driveway and they hired a guy to come over with a tractor years ago and grade/churn the gravel up and get the ruts out. Then they bought 100 bags of concrete, then they just dumped the bags on the gravel and used a hand rake to spread the concrete (dry at this stage). Then use a garden hose to wet it down and it is still holding up I am told. 100 bags of concrete might cost $400, but worth a shot.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.