Posted by wfw on December 27, 2011 at 06:20:44 from (66.44.246.38):
In Reply to: OT Puter problem posted by Aaron Ford on December 26, 2011 at 18:42:32:
I have microsoft security essentials and malwarebytes running on three computers without any problems. the mse is from microsoft. it is free with free updates. as many problems as you seem to have I would recommend the paid version of malwarebytes. to cure your present problem I would reformat the hard drove and reload the operating system. you will need the version on disc or on the D drive on your computer. if you are going to try to get rid of the malware without reloading the system then run your scans in safe mode with networking. to get there just restart the computer and hit f8 repeatedly until it comes up. it will give you an option to start normally, start in safe mode, start in safe mode with networking, etc. in safe mode it only runs what has to run on your system. be sure to update any program to the new virus definitions prior to running to have the latest definations.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.