Tempered glass can not be cut - Period. The way normal glass is made is that it is cooled down very slowly and evenly. This allows the glass to shrink uniformly while cooling. Tempered glass is cooled quickly. Because of the amount of mass there, the edges cool first and solidify. Then as the inside cools it wants to shrink but can't since the outside of the glass piece has solidified. The inside then is pulling on the inside and ends up under tension. If any part of the sheet weakens, the entire piece is able to release the internal tension and shatters into the 1/4" pieces we all love.
If you untemper the glass by reheating it (Usually while floating on a pool of mercury) and then cool it slowly the glass can be cut just like normal glass. It must then be retempered.
Laminated glass is 2 pieces of normal glass with either a mesh grid work or plastic sheet in between. This can be cut normally but is a bit more difficult because of the inside layer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
