Posted by gregk on December 23, 2011 at 15:32:59 from (75.105.32.52):
In Reply to: Re: simple wiring question posted by Hal/Eastern Washington on December 23, 2011 at 14:27:53:
I had the same thing happen to me once when there was a 1500 watt heater plugged into that circuit. In my case I could see a haze in the room and hallway as well as smell it melting, but I caught it in time. I wire new houses all the time and also do plenty of repair on older houses. I can't count the number of times there have been problems with outlets that have not been tailed out. That is not to say that I haven't had a pigtailed wire "unscrew" itself as I was pushing it back in the box, but that is more due to not twisting the wires together tight enough. Also if you do enough of anything something will mess up. My vote is on pigtailing them out for safety and troubleshooting ease, however here there is no code prohibiting doing it the other way.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.