Posted by gregk on December 21, 2011 at 19:16:58 from (75.107.96.58):
In Reply to: OT Home school posted by pat sublett on December 21, 2011 at 16:25:28:
Congratulations! Sounds like your grandson has his head screwed on straight. As far as home schooled being better than public schools, that seems like comparing apples to oranges. Both have benefits and drawbacks, but the biggest factor is the kid. That's right, the kid who excells in a public/social environment may fail in a home school environment and vice versa. I think the smaller classroom is more conductive to learning, but the larger social atmosphere may be more helpful later in life. Once again it depends on the child, and I have been around both kinds all my life. My oldest boy has autism. We send him to a public school that I went to but is rapidly losing students since the rural population is still in a decline around here. He is in a class with 6 girls and no boys. The other children do a wonderful job of looking out for him and helping him. The issue in a larger school would probably be that lack of companionship and him getting teased a lot more(it pains me, but I expect him to get some teasing since kids can be that way, I just don't have to like it) Mom taught in this same school for over 20 years and the main change she hated was the No Child Left Behind Act. Her observation was that now the kids were taught to the test, not the general knowledge that they used to get. On the flip side Grandpa who taught school in a 1 room schoolhouse 80 years ago thought that was a better system than the one we have now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
