Posted by george md on December 06, 2011 at 21:32:12 from (209.213.167.201):
In Reply to: Re: Shop floor is dirt posted by Bob Huntress on December 06, 2011 at 19:37:47:
Bob,
I have 6000 sq ft of floor, some office , some machine shop and some service bays and none is more than 4 inch. In the bays I have had 977l and hein werner C-14B in without problem. Machine shop has a 3 inch spindle boring mill and 26 & 30 inch swing lathes & also 14 x 48 cylindrical grinder that is about 5 tons ,boring mill is 8+ tons lathes are about 3 tons each.
I highly recomend that you do NOT use rebar in 4 inch floor , as it will cause cracks in thin floors, works best in 6+ inch floor. I have no rebar in any of my floors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
