ABSOLUTEY YES IMHO We already hashed this over yesterday and franky most are bored to tears lol.
Look here for detailed reasons why with supporting current measurements. Other opinions may differ (saying it makes no difference) but until I see their evidence and supporting current measurements showing it makes no difference, Im going with what Smart Gauges experiments indicate as it makes sense to me, a retired electrical engineer, BUT they may be wrong, same as anyone her including myself may be wrong.
NOTE IM NOT GUARANTEEING SMART GAUGES RESULTS IM ONLYYYYYY SAYING IT MAKES ENGINEERING SENSE TO ME, BUT IM LONG RETIRED AND RUSTY ON THIS.
Its your choice, read Smart Gauges webpage, take your own current measurements, read opinions here and if anyone has taken precise current measurements that show smart guages people are all wet consider that also...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
