Definitely want to incorporate manure to preserve the nutrient value. I see mixed information as to the benefits of fall tillage. We did extensive fall tillage in the 1980's and it almost was a detriment as a lot of those winters were open and seemed to "freezer burn" the organic material in the soil reducing tilth and water holding capacity. Then it seems like we would have a prolonged wet spell in March or April followed by a very warm dry spell. The net result being the soil dried to large chunks on top from the chisel pattern yet too wet to work to keep the chunking from happening. Anymore the fields we fall tilled are done so that we know the possibility of spring chunking is minimal. The rest in the spring we find it works just as well to work in thin layers going progressively deeper each time. If dry enough have the cultipacker following along as you make each pass. I would love to fully utilize no-till and the price of drills are getting down to where a small operator such as myself could afford one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.