Posted by VicS on November 25, 2011 at 19:29:55 from (69.160.179.243):
In Reply to: Lower Link Balls posted by S Farmall on November 25, 2011 at 18:11:08:
I changed our 6140 Allis, Tractor supply had some that was cat 1 and had another hole that was cat 2. You have changed bearings that were in a cast block? You remember that there were two notches in the block, and you turned the bearing to these notches and it would fall out. Turn your old balls sideways and heat the end in two places 180 degrees from each other, when is really hot the ball will drive out. Then pop the new one in and heat the end some more and peck it back like it was. Worked for me. Vic
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
