Posted by LJD on November 19, 2011 at 14:44:08 from (72.171.0.144):
In Reply to: measurements for LJD posted by carogator on November 19, 2011 at 14:10:48:
Thanks - you are a life-saver. After making a 1600 mile round-trip - I lost the paper drawing I made and have been kicking myself ever since. All I could remember is the two groups of bolt-pairs are not the same distance apart.
I ran down to a farm down the road where a slightly newer IH hoes sits. Went to measure it and found out it has NO pump in front - so NG.
I found a Komatsu dealer that has a new old-stuck hub and he quoted me a price of over $400. That's why I'm going to make my own -or adapt something similar. My 4000 Ford Industrial has a four-bolt rubber-cushioned drive hub I might be able to adapt with some work. That I can buy new for less then $50.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
