Posted by Mike M on November 18, 2011 at 10:02:07 from (24.140.0.120):
I have to install a metric oil seal and these are the ones with the outer rubber covering. I tried to find one with a metal outside but no luck. With a metal outside I'd likely use locktite. My housing has a small indented spot from either casting flaw or previous damage. So I was wondering what all kinda tips I will find out here as to how to make sure this seal stays sealed and in place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
