Posted by Billy NY on November 18, 2011 at 08:59:38 from (72.231.148.182):
In Reply to: Proof... posted by jose bagge on November 18, 2011 at 08:28:04:
They do it here too,every so often, one will try an slide into home base, unintentionally of course, after too much stall time due to inclement weather. You want to let em out, but sometimes the pasture is too slick. It's a different ball game from now til spring, as to when they can go into the pasture or just the riding arena, they sure need their "out" time and all the rest, can keep a person real busy they can.
What I do not like about the southern yellow pine they pressure treat and mill for posts, smaller dimension like 4"-5" is given that its one of or the only needle bearing species, that is or almost is a hardwood (correct me here), and they are brittle. That knot is a tell tale sign, just drop one like that from about 12'-0" up, it will snap in half and leave a point, luckily the point was on the top half that broke off. Those darn post and rail fences do it to, we have a fair amount of that, and they snap near a pocket and leave a sharp, dangerous point sticking up, we have had good pulling these, gluing and clamping, not to be cheap, they are expensive so I do repair any that will glue up, they are pressure treated, but not S.Y.P., seem like a hardwood though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
