Posted by TonyIN on November 18, 2011 at 05:19:37 from (74.215.182.169):
In Reply to: Waste oil heat? posted by Row Crop on November 18, 2011 at 02:27:17:
While I don"t have a radiant shop floor (my shop is still a gravel base... no bldg yet), we have done a few radiant heat projects. They key, like everything else, is in the prep and installation.
I know of some who store their toys in a shop and to keep them in good shape, they installed the radiant tubing but run it off a hot water heater. This system is setup to keep the area above 40 deg. but not too much higher. Their operational cost is very low. May not be what you"re looking for but may also be an economical option as far as utility costs.
I"ve been thinking about heat for my shop when I get it built and have been considering using a radiant heat mat (electric) in just a designated area. We use them a lot in the high end residential bathrooms. Nothing like setting cabinets on a nice warm tile floor. In a shop I would have it where I would be working on something and the t-stats for them are completely programmable so I would only be using electricity when needed. May not do much for heating the shop, but will take the edge off when you"re working.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
