Posted by Billy NY on November 14, 2011 at 09:30:05 from (72.231.148.182):
In Reply to: OT: Barn Repair posted by James Howell on November 14, 2011 at 07:52:40:
Nice to get it done isn't it ? Just an open wound until that last piece of tin goes on.
When I first saw the photos, I'm like..... those spans between the perlins, forgetting ... no snow load, or at least you guys are not supposed to get snow ! LOL !
We had a similar problem old barn, started settling, then a heavy accumulation of wet snow, left a big hole in the barn. The rebuild was an absolute trying experience, bitter cold, (should have been done in good weather, note to self, never again, new posts, trusses, 2x4 rough cut perlins and new tin, in about 6 weeks. Given the size of this one, the 50' span and 4'-0" on center trusses, an absolutely difficult job for myself and 2 others. Not to hijack your thread, here's some photos:
Started off with the '64 F600 and local sawmill:
Hemlock 6"x6" just sawn, boss says given the age of the barn, no P.T. posts:
Start setting trusses:
F600 makes nice work platform !
All those darn frozen, heavy perlins 19" spacing, just before the tin went up:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
