Posted by Heat Houser on November 14, 2011 at 09:05:03 from (69.66.35.73):
In Reply to: corn silage question posted by jacksonduper on November 13, 2011 at 20:11:31:
If you have a bit of a slope that is convienient to where you will feed, I would dig a pit silo.
To keep the silage fresh, you will have to feed to a depth of about 4 inches per day across the face. Feeders will need about 7 lbs per day per 100 lbs body weight. Silage weighs about 35 lbs per cubic foot.
Got 10 head at 500 lbs? 5 X 7 = 35 lbs per day per head. 10 head X 35 lbs is 350 lbs per day from the face. 350 / 35 (lbs/cu ft) = 10 cubic feet of silage per day.
Since cu ft is W X H X D, 10 cu ft/ .333 Depth = 30 sq ft of face need to keep the silage fresh. (the .333 is 4 inches converted to feet) Bunker (face) is 8 ft wide? 30 sq ft /8 = 3.75 height of face.
Of course, these are average estimates only but will be close. You will need to adjust the amounts for the number of head you have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
