Posted by billonthefarm on October 23, 2011 at 18:06:36 from (97.64.182.189):
Well maybe more operator error really but this morning cheking cows I thought I would take a short cut from a creek up out of the valley. I was doing just fine till I got to the very top and a front wheel went up on a little bump and I felt it start to tip over. I just stepped off and watched. Nick wasnt far behind me so he saw it as well. It flipped 6 or 7 times at a impressive rate of speed and would have went all the way to the creek but it slammed into a down tree and came to rest upside down. Nick hollerd to make sure I was fine and I didnt have a mark on me and I never even fell down. My trusty ride sustained some damage. We flipped it up and pulled it away from the tree. At this point we are about a mile from the pickup and 2 miles from a public road. I looked at it and started it up and drove it to the trailer. Front rims bent, a arm, front and rear racks, dash has serious damage, handle bars are in a bad way, pretty much everything ahead of the seat is now tweaked and some things behind! Luckily I had left wrigley in the truck or he would have been along for the ride as well. Anyway nobody hurt so all is well but I think I need a 4 wheeler. What is a good sturdy farm tough 4 wheeler. This was a JD buck 500. It was a tough sucker and had some guts. They dont make them anymore and I hear parts could be hard to get. We have a artic cat and a yahma both. I like the artic cat alot. The yamaha dealer is good. Anything else out there to look at? Any good models to check out? By the way, be careful out there! bill
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
