Posted by Bob Huntress on October 19, 2011 at 21:28:32 from (98.66.34.218):
In Reply to: O/T: Pickup/SUV ? posted by Brad Gyde on October 19, 2011 at 19:50:30:
I'm not a push a (insert Ford or Chevy) rather than drive a (insert the other one). Fords are a bit heavier and have bigger engines(not an absolute), while Chevy/GMC have more available parts, and more room to work. Neither of those two are bad trucks, and either would be considered reliable. Dodge is a different story, however. I understand that as I buy used, that I assume a given amout of repair, yet, I managed the GSA fleet for the USCG, prior to my retirement, earlier this month. The company does honor it's warranty, yet, I do not believe that it should be needed close to as often as it is. They also have lighter rear ends standard, which can be solved by getting an optional heavier one. That's my imput. Ford and GM are both fine trucks and will likely serve your wife fine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
