Posted by Billy NY on October 17, 2011 at 07:34:44 from (74.67.3.54):
Does anyone have a set hanging they could measure, I've found a couple sets alleged to be for 13.6x28, but one set I tried was too small, probably for a IH Cub, as the seller, who restores those, got a few pairs when buying tractors and or parts. Set was nice double rings too, twice as many cross chains. The other set was alleged to have been on Ferguson 35, which would appear to have that size tire, they are about 9 or 10'long if I recall correctly and 21" wide. Just wondering what the dimensions are to confirm any I find will work.
I would assume that measuring the sidewall where the outside chain holding the cross chains would give you a close enough dimension, like a dummy, before I went over to the guys shop, I measured the outside circumference !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step 12-Volt Conversion - by Bob Melville. Below are step by step instructions to convert a 6 volt Farmall M or Super M with battery (not magneto) ignition to a 12 volt alternator electrical system.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
